After-sales Service | Online support, Field installation, commissioning and training, Fie | Brand Name | VT |
Parameter
Item |
VT-16B |
Inlet wire diameter |
16mm (Customizable) |
Outlet wire diameter |
5.2mm(Customizable) |
Roller No |
16 (Customizable) |
Main cylinder length |
450mm |
Voltage(V) |
3×380(-5%+10%) |
Frequency(Hz) |
50 (±2%) |
Cooling method |
Spray |
Main motor power |
18.5kw |
Water pump motor |
0.25kw |
Max speed |
62m/min |
Roller compression ratio |
16% |
Machine dimension |
3300*900*1360mm |
Machine weight |
3000kg |
Capacity |
7T/day |
1.Application:
We developed VT-16B solder roll machine with reference to the international advanced technology in this field. It’s mainly apply to the rolling of lead-free tin solder wire, can be customized for tin and zinc alloy solder wire, silver alloy wire and some special hard alloy wire rolling etc.( Patent No: ZL ******** 7)
2.Equipment :
1)Machine structure: VT-16B roll machine is make up of wire take-up shaft, wire adjusting device, rolling device, pay-off device, cooling & lubricating system, drive system and electric control system.
2)Electric control: Controlled by inverter, speed change per different wire diameters.
3.Advantage
1)Very durable Roller, the roller has been processed with many special process to reach its hardness for rolling very hard alloys, our rolling machine not only process tin solder wire, but silver wire and other very hard alloy wire as well.
2 )Make high density solder wire, because of its scientific roller structure design, it makes the solder wire with good quality and good weld ability, Good for later drawing process, avoid the wire breakage problem.
3)High efficiency, very easy for wire inlet, not same as drawing machine which need make wire inlet go through too many dies.Wire diameter as below
16mm~5.2mm 7T/10hr
14mm~4.6mm 4.5T/10hr
12mm~3.8mm 3.7T/10hr
9mm~2.0mm 2.5T/10hr
4)Low noise: because of its special roller structure, not only make the solder wire with tighter quality but make nearly no noise. However, it is an inevitable disadvantage of the drawing machine. While roll machine can well solved this problem and make lower noise. The noise of the traditional drawing machine comes from the shaking wire clash the dies and roller. This is due to the corresponding slide of the wire and roller. The wire will be easily broken if without this kind of slide. So rolling machine is sure to replace drawing machine at a great point.
5)Low Energy consumption
There’s four ways of energy consumption for the wire drawing machine:
a) Wire getting smaller and smaller and give heat by distortion;
b) Wire clash the roller and give heat by attrition;
c) Wire pass through the dies and give heat by distortion;
d)Wire pass through the dies and give heat by attrition.
While roll machine have two ways of energy consumption:
a) Wire give heat by rolling distortion (This is not inevitable energy consumption);
Wire give heat by rolling attrition. This kind of heat giving should smaller than wire pass through dies as the roll machine was rolling attrition while the wire drawing machine is sliding attrition.
May contact Joey for more details.
Email:****
Tel.+********